Stinger CB350F: Stinger Tail

Posted: November 15, 2016 by noahyamen

Since the last post for this bike, I've installed the Dyna S electronic ignition and we've completed the tank. I've picked up a new set of carbs as well, since I found the original ones had several stripped threads where the bowls were held in place.

With some minimal chopping to the frame done, it was time to start fabricating the "stinger" tail hoop. First step was cutting pipe at an angle, then welding it back together. Then heated it up with the torch and bent the first set of curves into it.

Photos